BJD head— “Jed”

**Due to its size, this doll head cannot be shipped with any A4 prints or larger. Please order them in separate orders. However, A5 or smaller sized prints, keychains/standees (smaller items) and that camping cup are totally fine.**

**ONLY THE BALD HEAD. NO MAKE-UP (FACE-UP), NO EYEBALLS, ACCESSORIES OR OTHER BODY PARTS INCLUDED. ALSO I CANNOT INCLUDE THE E LITTLE MAGNETS INSIDE DUE TO POST OFFICE RESTRICTIONS. HOWEVER I CAN TRY MAILING THEM SEPARATELY IN A TRACKED ENVELOPE IF YOU NEED (NO EXTRA CHARGED). LET ME KNOW IF YOU NEED THEM. SORRY FOR THE INCONVENIENCE!**

**Please refrain from using as reference for drawing (especially tracing!) Danny/Jed! This is for collection purposes, and its 3D model was built from my Jed drawing so it would be kinda awkward if used as tracing material for same characters :( I am so sorry!!!**

**Recast prohibited**

Ball-jointed doll head "Jed"
3D printed
UV resin

Head circumference: 23.4cm
Neck circumference: 13cm
(+-2mm)
Ideally for height 75cm dolls

Design and sculpting: Aka
Editing and printing: HeySheep
(Again thanks for HeySheep saving my life XD)

Two paler skin tone available:

Pale ivory— pinkish, pale ivory
Warm ivory— warm, fair ivory

Both skin tones are pale. The difference is their undertone— one is pink and the other yellow. Warm ivory is slightly darker than pale ivory.

Image 1: Pale ivory under indoor white light

Image 2: Pale ivory under indoor yellow light. Warm ivory looks alike to this image when under indoor white light

Image 3: Pale ivory under dimmer indoor yellow light

Image 4: Left pale ivory, right warm ivory. Contact me to get Heysheep's resin colour card. Actual colours vary

Image5: Pale ivory after face-up done by artist Maple. Image taken indoor with only sunlight, indoor light turned off. Face-up not included

*Only the printed head without face-up. Not including any wigs, body, costumes or accessories etc.

*Recommended eyeballs size: 14~16mm.

*Airmail policy does not allow me to post orders including magnets, so the head will NOT include the magnet pieces. Those tiny magnets are easy to get online (Amazon etc) or in arts&crafts shops. You will need four pieces of dia. 8mm x thickness 3mm magnets.

*3D-printed, not casted. Hand-sanded by HeySheep themselves, not factory made, so please expect a little imperfection. HeySheep mentioned usually you can apply face-up directly, but you might want to check and sand it a little bit more before you do so.

*Avoid longterm sunlight/ UV or heat. Keep it in a cool and dry place. Yellowing is unavoidable as it's made of resin, but keeping away from heat and sun do help slowing the process a lot.

*Will be shipped in box with paper fillings, bubble wrappings and air pillow.

*Colours may vary.

Please read Shipping and Policy page for further information.